AOD 9604 reconstitution and dosage explained: how much bacteriostatic water to add, typical daily dosing, injection timing, storage, and safety notes.
AOD 9604 is reconstituted by adding bacteriostatic water to the lyophilized powder, usually 1 mL to 2 mL for a 5 mg vial, and most research protocols use 250 mcg to 500 mcg injected subcutaneously once per day. The number cited most often is 300 mcg daily. Getting the dilution right matters more than anything else, because every dose you draw afterward depends on it.
What AOD 9604 Is
AOD 9604 is a synthetic peptide modeled on the 176-191 fragment of human growth hormone. It is studied mainly for fat metabolism because it mimics part of HGH's fat-releasing activity without the blood sugar effects associated with full growth hormone.
AOD 9604 is not FDA-approved for human use in the United States. It is sold as a research chemical, so purity, actual peptide content, and labeling vary between suppliers — and those differences change how much you are really measuring.
AOD 9604 Reconstitution: Step-by-Step
The goal of aod 9604 reconstitution is a clear, stable solution at a concentration you can draw accurately. Small mistakes in water volume become large mistakes in dose.
What You Need
- Lyophilized AOD 9604 vial (most often 2 mg or 5 mg)
- Bacteriostatic water containing 0.9% benzyl alcohol
- Alcohol swabs
- U-100 insulin syringes (0.5 mL or 1 mL)
- Sharps container
The Process
- Wash your hands and clear a clean work surface.
- Swab the rubber stoppers on both vials and let them air dry.
- Draw your chosen volume of bacteriostatic water into a syringe.
- Insert the needle at an angle so the tip rests against the inside glass wall, not the powder.
- Push the water out slowly down the side of the vial. Never spray it directly onto the powder, because foaming can damage the peptide.
- Withdraw the needle and swirl the vial gently between your fingers until the powder is fully dissolved. Do not shake it.
- Write the date, water volume, and final concentration on the label, then refrigerate the vial.
The finished solution should be clear and colorless. Cloudiness, floating particles, or a gel-like texture means the vial should be thrown out.
| Vial size | Bacteriostatic water added | Concentration | 300 mcg dose equals |
|---|---|---|---|
| 5 mg | 1 mL | 5 mg/mL | 6 units on a U-100 syringe |
| 5 mg | 2 mL | 2.5 mg/mL | 12 units |
| 5 mg | 3 mL | 1.67 mg/mL | 18 units |
| 2 mg | 1 mL | 2 mg/mL | 15 units |
| 2 mg | 2 mL | 1 mg/mL | 30 units |
More water makes measurement easier but creates a larger injection volume. Fewer milliliters give a smaller shot but leave less room for error on the syringe.
AOD 9604 Dosage: Common Protocols
Published research on aod 9604 dosage spans a range of amounts, but the pattern most people encounter is 300 mcg once per day. Because the peptide clears quickly, some protocols split the daily total into two smaller shots.
| Protocol | Daily total | Frequency | Typical context |
|---|---|---|---|
| Conservative | 250 mcg | Once daily | First cycle, tolerance check |
| Standard | 300 mcg | Once daily | Most commonly cited amount |
| Split dose | 300 mcg | 150 mcg twice daily | Morning fasted and pre-workout |
| Higher | 500 mcg | Once daily | Less common, no clear added benefit |
Once the concentration is known, an aod 9604 dosage protocol is mostly arithmetic: divide the target dose in milligrams by the concentration in mg/mL, then convert milliliters to units at 1 unit = 0.01 mL.
Where and How to Inject
Subcutaneous shots go into the abdomen, outer thigh, or upper arm. Rotate the site each time and inject at a 45- to 90-degree angle. If the vial just came out of the refrigerator, let the syringe sit in your hand for a minute first.
Timing, Storage, and Cycle Length
AOD 9604 is typically injected on an empty stomach, either in the morning or before training, with food delayed about 20 to 30 minutes. A large insulin response may blunt the fat-releasing effect researchers are interested in.
Storage protects the accuracy of everything above, because a peptide that has degraded delivers less than the label suggests.
| Form | Storage | Practical shelf life |
|---|---|---|
| Lyophilized powder | Freezer at -20°C, or refrigerator for short periods | 12 to 24 months sealed |
| Reconstituted solution | Refrigerator at 2-8°C, upright and away from light | About 4 to 6 weeks |
| Reconstituted, left at room temperature | Not recommended | Hours to a few days |
| Cloudy or gelled solution | Discard immediately | Not usable |
Most self-reported cycles run 8 to 12 weeks. There is no established guidance on breaks, and a common convention is matching time off to time on.
Side Effects, Safety, and Stacking
AOD 9604 is generally described as well tolerated in short-term studies. Reported issues tend to be mild and include redness at the injection site, headache, fatigue, and occasional nausea.
Anyone weighing aod 9604 benefits and side effects should also weigh what is unknown. Long-term human safety data are limited, the compound is not FDA-approved, and regulators have issued warnings about compounded and gray-market peptides. Speak with a healthcare professional before injecting anything, particularly if you are pregnant, nursing, or managing a chronic condition.
Stacking is common in research settings. Many people ask about aod-9604 and mots-c together because both are studied for metabolic effects and are often run on the same daily schedule. Controlled human data do not establish that combining them adds anything.
What Results Actually Look Like
Two weeks is a short window. Most self-reported logs over the first two weeks describe changes in appetite or water weight rather than real fat loss.
- Weeks 1-2: little to no visible change for most people.
- Weeks 4-6: gradual shifts in body composition when diet and training stay consistent.
- Weeks 8-12: the point where before-and-after comparisons start to mean something.
Outcomes depend heavily on calorie intake, protein, sleep, and training. A peptide does not override a poor diet, and no injection replaces basic habits.
Verify your source, verify your math, and reread the concentration on the label every time you draw a dose. Reconstitution accuracy is what makes any dosage number meaningful.
Frequently Asked Questions
How much bacteriostatic water should I add to a 5 mg AOD 9604 vial?
Most people add 1 mL to 2 mL of bacteriostatic water per 5 mg vial. Adding 1 mL creates a 5 mg/mL solution, so a 300 mcg dose is 6 units on a U-100 syringe; adding 2 mL creates 2.5 mg/mL, so the same dose is 12 units. More water makes measurement easier but increases injection volume.
What is the typical AOD 9604 dosage per day?
The most commonly cited amount is 300 mcg injected subcutaneously once per day. Research and self-reported protocols range from roughly 250 mcg to 500 mcg, and some users split the total into two 150 mcg injections. AOD 9604 is not FDA-approved for human use, so no official dosing standard exists.
How long is reconstituted AOD 9604 stable?
Reconstituted AOD 9604 should be kept refrigerated at 2-8°C and is generally considered usable for about 4 to 6 weeks. Discard it if it turns cloudy, shows particles, or becomes gel-like. Lyophilized powder stored in a freezer keeps far longer, often 12 to 24 months.
This page provides educational research information and does not replace medical advice, diagnosis, or treatment.